| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
rds: tcp: unregister sysctl before tearing down listen socket
rds_tcp_exit_net() frees the per-netns RDS TCP listen socket via
rds_tcp_kill_sock() before unregistering the per-netns sysctl table. Since
rds_tcp_skbuf_handler() derives the netns from
rtn->rds_tcp_listen_sock->sk, a concurrent sysctl write can race with
netns teardown and dereference the freed socket/sk.
KASAN reports the race as:
BUG: KASAN: slab-use-after-free in rds_tcp_skbuf_handler+0x2aa/0x2e0
rds_tcp_skbuf_handler net/rds/tcp.c:721
proc_sys_call_handler fs/proc/proc_sysctl.c
vfs_write fs/read_write.c
__x64_sys_pwrite64 fs/read_write.c
Fix this by unregistering the RDS TCP sysctl table before calling
rds_tcp_kill_sock(). unregister_net_sysctl_table() prevents new sysctl
handlers from starting and waits for in-flight handlers to finish, so
the listen socket can then be released safely. The fix was tested
against the linked reproducer. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: set new_stream to NULL after release
In dm_update_crtc_state(), the skip_modeset path releases new_stream
via dc_stream_release() but does not set the pointer to NULL.
If a later error (e.g., color management failure) triggers the fail
label, the error path calls dc_stream_release() again on the same
dangling pointer, causing a double release and potential use-after-free.
Fix this by setting new_stream to NULL after the initial release.
(cherry picked from commit 99f3af19073b3ddbfd96e789124cce12c4277b28) |
| In the Linux kernel, the following vulnerability has been resolved:
media: vivid: check for vb2_is_busy() when toggling caps
The vivid_update_format_cap/out() functions must only be called if the
capture/output queue are not busy. But for the controls that select
the CROP/COMPOSE/SCALE capability that is not checked.
Only when streaming starts will they be set to 'grabbed' and it is
impossible to change the control, but between REQBUFS and STREAMON you
are still allowed to set these controls. Since vivid_update_format_cap/out
will change the format, this can cause unexpected results.
Besides adding these checks, also add a WARN_ON in
vivid_update_format_cap/out() if the queue is busy.
I'm 90% certain that this is the cause of this syzbot bug:
https://syzkaller.appspot.com/bug?extid=dac8f5eaa46837e97b89
But since we never have reproducers, it is hard to be certain. In any case,
these checks are needed regardless. |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: timer: don't re-enter an instance callback that is still running
The userspace-driven timer (utimer) TRIGGER ioctl calls
snd_timer_interrupt() directly with no serialization, so two threads
triggering the same utimer can run snd_timer_interrupt() on one
snd_timer concurrently.
snd_timer_process_callbacks() drops timer->lock around each instance
callback and marks the in-flight callback with the single
SNDRV_TIMER_IFLG_CALLBACK bit; snd_timer_close_locked() waits on that
bit to drain an in-flight callback before freeing the instance. The bit
cannot represent two concurrent callbacks: when a second interrupt
re-queues an instance whose callback is still running, both run at once,
the first to finish clears the bit, and the close-path drain then frees
the instance (and its callback_data) while the other callback is still
live - a use-after-free reachable by any user able to open
/dev/snd/timer, both via a user timer instance and via a sequencer queue
timer bound to the utimer.
snd_timer_interrupt() sets IFLG_CALLBACK before dropping timer->lock, so
a concurrent interrupt already observes it under the lock. Skip
re-queuing an instance (and its slaves) to the ack/sack list while its
callback is in flight; the accumulated pticks are delivered on the next
tick, so no event is lost. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmfmac: make release_scratchbuffers idempotent
brcmf_pcie_release_scratchbuffers() frees the shared.scratch and
shared.ringupd DMA buffers with dma_free_coherent() but does not clear
the pointers afterwards, unlike the sibling release_ringbuffers() which
NULLs commonrings/flowrings/idxbuf on release.
Both the bus_reset .reset callback (brcmf_pcie_reset) and
brcmf_pcie_remove() call release_scratchbuffers. When reset teardown
has run before removal, remove's own teardown would call
dma_free_coherent() a second time on the already-freed DMA allocation.
NULL the pointers after free, matching release_ringbuffers(), so a later
release observes that the allocation has already been released. This
patch makes repeated sequential release safe; the reset-work lifetime is
handled separately by the following patch.
This issue was found by an in-house static analysis tool. |
| In the Linux kernel, the following vulnerability has been resolved:
libceph: refresh auth->authorizer_buf{,_len} after authorizer update
ceph_x_create_authorizer() caches au->buf->vec.iov_base and
au->buf->vec.iov_len in struct ceph_auth_handshake. These
cached values are then used by the messenger connect code when
sending the authorizer.
ceph_x_update_authorizer() can rebuild the authorizer when a newer
service ticket is available. If the rebuilt authorizer no longer
fits in the existing buffer, ceph_x_build_authorizer() drops its
reference to au->buf and allocates a new one. If this is the final
reference, ceph_buffer_put() frees the old ceph_buffer and its
vec.iov_base, but auth->authorizer_buf still points at that freed
memory.
A subsequent msgr1 reconnect can therefore queue the stale pointer
and trigger a KASAN slab-use-after-free in _copy_from_iter() while
tcp_sendmsg() copies the authorizer.
Refresh auth->authorizer_buf and auth->authorizer_buf_len after a
successful authorizer rebuild so the messenger sends the current
buffer. |
| In the Linux kernel, the following vulnerability has been resolved:
fscrypt: Avoid dynamic allocation in fscrypt_get_devices()
When a blk_crypto_key starts being used or is evicted, fs/crypto/ calls
fscrypt_get_devices() to get the filesystem's list of block devices,
then iterates over them and calls blk_crypto_config_supported(),
blk_crypto_start_using_key(), or blk_crypto_evict_key() on each one.
Currently, the block device pointers are placed in a dynamically
allocated array. This dynamic allocation is problematic because:
- It can fail, especially at the fscrypt_destroy_inline_crypt_key() call
site when it's invoked for inode eviction under direct reclaim.
- fscrypt_destroy_inline_crypt_key() doesn't handle the failure. It
just zeroizes and frees the blk_crypto_key without calling
blk_crypto_evict_key(). That causes a use-after-free.
For now, let's fix this in the straightforward and easily-backportable
way by switching to an on-stack array. Currently the fscrypt
multi-device functionality is used only by f2fs, which has a hardcoded
limit of 8 block devices. An on-stack array works fine for that.
(Of course, this solution won't scale up to large number of block
devices. For that we'd need a different solution, like moving the block
device iteration into the filesystem. Or in the case of btrfs, which
will only support blk-crypto-fallback, we should make it just call
blk-crypto-fallback directly, so the block devices won't be needed.) |
| In the Linux kernel, the following vulnerability has been resolved:
phonet: pep: fix use-after-free in pep_get_sb()
pep_get_sb() doesn't consider that pskb_may_pull() might have relocated
the skb data, and continue to access the older pointer, causing UAF.
Reproduced under KASAN:
BUG: KASAN: slab-use-after-free in pep_get_sb+0x234/0x3b0
Read of size 1 at addr ff11000105510f50 by task repro/157
pep_get_sb+0x234/0x3b0
pipe_handler_do_rcv+0x5f7/0xa10
pep_do_rcv+0x203/0x410
__sk_receive_skb+0x471/0x4a0
phonet_rcv+0x5b3/0x6c0
__netif_receive_skb+0xcc/0x1d0
Refetch the header with skb_header_pointer() after pskb_may_pull(), so
the possibly stale pointer is no longer dereferenced. There are better
ways to solve this, but, this is the less instrusive one. |
| In the Linux kernel, the following vulnerability has been resolved:
net/sched: serialize qdisc_rtab_list against concurrent get/put
qdisc_get_rtab() and qdisc_put_rtab() mutate the process-global singly
linked list qdisc_rtab_list and a plain non-atomic 'int refcnt' with no
lock. This was only safe because every caller historically held the RTNL
mutex, which serialized all rate-table lookups, inserts and frees.
That invariant no longer holds. cls_flower sets
TCF_PROTO_OPS_DOIT_UNLOCKED, so tc_new_tfilter() keeps rtnl_held == false
for it and sets TCA_ACT_FLAGS_NO_RTNL. That flag propagates through
tcf_exts_validate_ex() -> tcf_action_init() -> tcf_action_init_1() ->
tcf_police_init(), which calls qdisc_get_rtab()/qdisc_put_rtab() with the
RTNL mutex NOT held. Two RTM_NEWTFILTER requests on different CPUs, each
adding a flower filter with a police action carrying the same rate, then
race on qdisc_rtab_list and on the non-atomic refcnt, leading to a
use-after-free / double-free of the kmalloc-2k struct qdisc_rate_table.
qdisc_rtab_list is a single global (not per-netns), so the corrupted
object is shared system-wide.
BUG: KASAN: slab-use-after-free in qdisc_put_rtab+0x12f/0x160
qdisc_put_rtab+0x12f/0x160
tcf_police_init+0xda9/0x1590
tcf_action_init_1+0x460/0x6b0
tcf_action_init+0x439/0xa40
tcf_exts_validate_ex+0x42d/0x550
fl_change+0xddd/0x7da0
tc_new_tfilter+0xaa7/0x2420
rtnetlink_rcv_msg+0x95e/0xe90
which belongs to the cache kmalloc-2k of size 2048
Protect qdisc_rtab_list and the refcount with a dedicated spinlock. The
(sleeping, GFP_KERNEL) allocation in qdisc_get_rtab() is performed before
taking the lock; if a concurrent inserter added an identical table in the
meantime the freshly allocated one is freed under the lock, so no
duplicate is leaked. qdisc_put_rtab() now decrements the refcount and
unlinks under the same lock. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_uart: clear HCI_UART_SENDING when write_work is canceled
HCI_UART_SENDING bit in tx_state means write_work is pending and blocks
queueing it again. Currently this bit is not cleared when canceling the
work in hci_uart_close(), which blocks future writes when device is
reopened later if write_work was pending.
Fix by clearing HCI_UART_SENDING when canceling the work.
Also make clearing of tx_skb safe by using disable_work_sync +
enable_work instead of just cancel_work_sync. hci_uart_flush() purges
the proto tx queue so we can cancel the pending write_work there,
instead of doing it just in hci_uart_close(). Re-enable and possibly
requeue the work after queue flush. |
| A double free issue has been identified in libarchive's RAR5 reader. During parsing of a specially crafted RAR5 archive, the filtered_buf pointer may remain stale after being freed during unpacking state reinitialization. Subsequent processing of another archive entry can trigger a second free of the same memory region, resulting in a double-free condition. Successful exploitation may cause applications using the vulnerable libarchive API to terminate unexpectedly, leading to a denial of service. |
| It was discovered that a nft object or expression could reference a nft set on a different nft table, leading to a use-after-free once that table was deleted. |
| A use-after-free exists in the Linux Kernel in tc_new_tfilter that could allow a local attacker to gain privilege escalation. The exploit requires unprivileged user namespaces. We recommend upgrading past commit 04c2a47ffb13c29778e2a14e414ad4cb5a5db4b5 |
| In the Linux kernel, the following vulnerability has been resolved:
PCI: endpoint: pci-ep-msi: Fix error unwind and prevent double alloc
pci_epf_alloc_doorbell() stores the allocated doorbell message array in
epf->db_msg/epf->num_db before requesting MSI vectors. If MSI allocation
fails, the array is freed but the EPF state may still point to freed
memory.
Clear epf->db_msg and epf->num_db on the MSI allocation failure path so
that later cleanup cannot double-free the array and callers can retry
allocation.
Also return -EBUSY when doorbells have already been allocated to prevent
leaking or overwriting an existing allocation. |
| Use after free in Windows DWM Core Library allows an authorized attacker to elevate privileges locally. |
| Double free in Windows Secure Socket Tunneling Protocol (SSTP) allows an unauthorized attacker to execute code over a network. |
| Use after free in Capability Access Management Service (camsvc) allows an authorized attacker to elevate privileges locally. |
| In the Linux kernel, the following vulnerability has been resolved:
power: reset: linkstation-poweroff: fix use-after-free in the linkstation_poweroff_init()
Move of_node_put(dn) after the of_match_node() call, which still needs
the node pointer. The node reference is correctly released after use. |
| In the Linux kernel, the following vulnerability has been resolved:
fpga: region: fix use-after-free in child_regions_with_firmware()
Move of_node_put(child_region) after the error print to avoid accessing
freed memory when pr_err() references child_region.
[ Yilun: Fix the Fixes tag ] |
| Use after free in Windows Autopilot allows an authorized attacker to elevate privileges locally. |
