| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Off-by-one error vulnerability in the transmission component in Synology Replication Service before 1.0.12-0066, 1.2.2-0353 and 1.3.0-0423 and Synology Unified Controller (DSMUC) before 3.1.4-23079 allows remote attackers to execute arbitrary code, potentially leading to a broader impact across the system via unspecified vectors. |
| In the Linux kernel, the following vulnerability has been resolved:
modpost: fix off by one in is_executable_section()
The > comparison should be >= to prevent an out of bounds array
access. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/radeon: Fix integer overflow in radeon_cs_parser_init
The type of size is unsigned, if size is 0x40000000, there will be an
integer overflow, size will be zero after size *= sizeof(uint32_t),
will cause uninitialized memory to be referenced later |
| In the Linux kernel, the following vulnerability has been resolved:
i2c: rtl9300: ensure data length is within supported range
Add an explicit check for the xfer length to 'rtl9300_i2c_config_xfer'
to ensure the data length isn't within the supported range. In
particular a data length of 0 is not supported by the hardware and
causes unintended or destructive behaviour.
This limitation becomes obvious when looking at the register
documentation [1]. 4 bits are reserved for DATA_WIDTH and the value
of these 4 bits is used as N + 1, allowing a data length range of
1 <= len <= 16.
Affected by this is the SMBus Quick Operation which works with a data
length of 0. Passing 0 as the length causes an underflow of the value
due to:
(len - 1) & 0xf
and effectively specifying a transfer length of 16 via the registers.
This causes a 16-byte write operation instead of a Quick Write. For
example, on SFP modules without write-protected EEPROM this soft-bricks
them by overwriting some initial bytes.
For completeness, also add a quirk for the zero length.
[1] https://svanheule.net/realtek/longan/register/i2c_mst1_ctrl2 |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Fix possible underflow for displays with large vblank
[Why]
Underflow observed when using a display with a large vblank region
and low refresh rate
[How]
Simplify calculation of vblank_nom
Increase value for VBlankNomDefaultUS to 800us |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mwifiex: Fix OOB and integer underflow when rx packets
Make sure mwifiex_process_mgmt_packet,
mwifiex_process_sta_rx_packet and mwifiex_process_uap_rx_packet,
mwifiex_uap_queue_bridged_pkt and mwifiex_process_rx_packet
not out-of-bounds access the skb->data buffer. |
| An Integer Overflow or Wraparound vulnerability [CWE-190] in version 7.4.4 and below, version 7.2.10 and below; FortiSASE version 23.4.b FortiOS tenant IPsec IKE service may allow an authenticated attacker to crash the IPsec tunnel via crafted requests, resulting in potential denial of service. |
| Windows NTFS Elevation of Privilege Vulnerability |
| NSF Unidata NetCDF-C NC Variable Integer Overflow Remote Code Execution Vulnerability. This vulnerability allows remote attackers to execute arbitrary code on affected installations of NSF Unidata NetCDF-C. User interaction is required to exploit this vulnerability in that the target must visit a malicious page or open a malicious file.
The specific flaw exists within the parsing of NC variables. The issue results from the lack of proper validation of user-supplied data, which can result in an integer overflow before allocating a buffer. An attacker can leverage this vulnerability to execute code in the context of the current user. Was ZDI-CAN-27266. |
| An integer underflow vulnerability exists in the `nextstate()` function in `gpsd/packet.c` of gpsd versions prior to commit `ffa1d6f40bca0b035fc7f5e563160ebb67199da7`. When parsing a NAVCOM packet, the payload length is calculated using `lexer->length = (size_t)c - 4` without checking if the input byte `c` is less than 4. This results in an unsigned integer underflow, setting `lexer->length` to a very large value (near `SIZE_MAX`). The parser then enters a loop attempting to consume this massive number of bytes, causing 100% CPU utilization and a Denial of Service (DoS) condition. |
| The HTTPS server on Tapo C200 V3 does not properly validate the Content-Length header, which can lead to an integer overflow. An unauthenticated attacker on the same local network segment can send crafted HTTPS requests to trigger excessive memory allocation, causing the device to crash and resulting in denial-of-service (DoS). |
| FontForge GUtils XBM File Parsing Integer Overflow Remote Code Execution Vulnerability. This vulnerability allows remote attackers to execute arbitrary code on affected installations of FontForge. User interaction is required to exploit this vulnerability in that the target must visit a malicious page or open a malicious file.
The specific flaw exists within the parsing of pixels within XBM files. The issue results from the lack of proper validation of user-supplied data, which can result in an integer overflow before allocating a buffer. An attacker can leverage this vulnerability to execute code in the context of the current process. Was ZDI-CAN-27865. |
| ImageMagick is free and open-source software used for editing and manipulating digital images. Prior to version 7.1.2-12, in the WriteSVGImage function, using an int variable to store number_attributes caused an integer overflow. This, in turn, triggered a buffer overflow and caused a DoS attack. Version 7.1.2-12 fixes the issue. |
| An integer overflow in the RTPS protocol implementation of OpenDDS DDS before v3.33.0 allows attackers to cause a Denial of Service (DoS) via a crafted message. |
| An integer overflow in eProsima Fast-DDS v3.3 allows attackers to cause a Denial of Service (DoS) via a crafted input. |
| An integer overflow vulnerability exists in the write method of the Buffer class in Robocode version 1.9.3.6. The method fails to properly validate the length of data being written, allowing attackers to cause an overflow, potentially leading to buffer overflows and arbitrary code execution. This vulnerability can be exploited by submitting specially crafted inputs that manipulate the data length, leading to potential unauthorized code execution. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: don't return unset power in ieee80211_get_tx_power()
We can get a UBSAN warning if ieee80211_get_tx_power() returns the
INT_MIN value mac80211 internally uses for "unset power level".
UBSAN: signed-integer-overflow in net/wireless/nl80211.c:3816:5
-2147483648 * 100 cannot be represented in type 'int'
CPU: 0 PID: 20433 Comm: insmod Tainted: G WC OE
Call Trace:
dump_stack+0x74/0x92
ubsan_epilogue+0x9/0x50
handle_overflow+0x8d/0xd0
__ubsan_handle_mul_overflow+0xe/0x10
nl80211_send_iface+0x688/0x6b0 [cfg80211]
[...]
cfg80211_register_wdev+0x78/0xb0 [cfg80211]
cfg80211_netdev_notifier_call+0x200/0x620 [cfg80211]
[...]
ieee80211_if_add+0x60e/0x8f0 [mac80211]
ieee80211_register_hw+0xda5/0x1170 [mac80211]
In this case, simply return an error instead, to indicate
that no data is available. |
| In the Linux kernel, the following vulnerability has been resolved:
virtio-net: fix overflow inside virtnet_rq_alloc
When the frag just got a page, then may lead to regression on VM.
Specially if the sysctl net.core.high_order_alloc_disable value is 1,
then the frag always get a page when do refill.
Which could see reliable crashes or scp failure (scp a file 100M in size
to VM).
The issue is that the virtnet_rq_dma takes up 16 bytes at the beginning
of a new frag. When the frag size is larger than PAGE_SIZE,
everything is fine. However, if the frag is only one page and the
total size of the buffer and virtnet_rq_dma is larger than one page, an
overflow may occur.
The commit f9dac92ba908 ("virtio_ring: enable premapped mode whatever
use_dma_api") introduced this problem. And we reverted some commits to
fix this in last linux version. Now we try to enable it and fix this
bug directly.
Here, when the frag size is not enough, we reduce the buffer len to fix
this problem. |
| In the Linux kernel, the following vulnerability has been resolved:
NFSD: Prevent a potential integer overflow
If the tag length is >= U32_MAX - 3 then the "length + 4" addition
can result in an integer overflow. Address this by splitting the
decoding into several steps so that decode_cb_compound4res() does
not have to perform arithmetic on the unsafe length value. |
| In the Linux kernel, the following vulnerability has been resolved:
mm: avoid overflows in dirty throttling logic
The dirty throttling logic is interspersed with assumptions that dirty
limits in PAGE_SIZE units fit into 32-bit (so that various multiplications
fit into 64-bits). If limits end up being larger, we will hit overflows,
possible divisions by 0 etc. Fix these problems by never allowing so
large dirty limits as they have dubious practical value anyway. For
dirty_bytes / dirty_background_bytes interfaces we can just refuse to set
so large limits. For dirty_ratio / dirty_background_ratio it isn't so
simple as the dirty limit is computed from the amount of available memory
which can change due to memory hotplug etc. So when converting dirty
limits from ratios to numbers of pages, we just don't allow the result to
exceed UINT_MAX.
This is root-only triggerable problem which occurs when the operator
sets dirty limits to >16 TB. |
