| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: rtw88: check for PCI upstream bridge existence
pci_upstream_bridge() returns NULL if the device is on a root bus. If
8821CE is installed in the system with such a PCI topology, the probing
routine will crash. This has probably been unnoticed as 8821CE is mostly
supplied in laptops where there is a PCI-to-PCI bridge located upstream
from the device. However the card might be installed on a system with
different configuration.
Check if the bridge does exist for the specific workaround to be applied.
Found by Linux Verification Center (linuxtesting.org) with Svace static
analysis tool. |
| In Modem, there is a possible system crash due to improper input validation. This could lead to remote denial of service, if a UE has connected to a rogue base station controlled by the attacker, with no additional execution privileges needed. User interaction is not needed for exploitation. Patch ID: MOLY01826924; Issue ID: MSV-7301. |
| When NGINX Ingress Controller processes Ingress or TransportServer resources, an authenticated, remote attacker with permission to create or modify Ingress or TransportServer resources can cause the NGINX Ingress Controller process to terminate.
Impact:
The NGINX Ingress Controller control plane process terminates and enters a persistent crash loop while the malformed Ingress or TransportServer resource remains in the cluster. This vulnerability allows a remote, authenticated attacker with at least Ingress or TransportServer resource write access to cause a denial-of-service (DoS) on the NGINX Ingress Controller system. There is no data plane exposure; this is a control plane issue only.
Note: Software versions which have reached End of Technical Support (EoTS) are not evaluated. |
| Null pointer dereference in Windows Kernel allows an authorized attacker to elevate privileges locally. |
| Zeek before 8.0.9 contains a null pointer dereference vulnerability in its Kerberos protocol analyzer that allows unauthenticated remote attackers to crash the sensor by sending a crafted KRB_ERROR message with error-code 25 (KDC_ERR_PREAUTH_REQUIRED) containing a PA-DATA element with padata-type 2, 3, 11, or 19. Attackers can exploit a parser and analyzer state mismatch where proc_padata() dereferences an uninitialized pa_data_element field selected by the wrong parsing arm, triggering a crash via a single UDP or TCP packet to port 88 without any credentials or prior authentication. |
| Null pointer dereference in Active Directory Domain Services allows an authorized attacker to deny service over a network. |
| Null pointer dereference in Windows SMB Server allows an authorized attacker to deny service over a network. |
| LibVNCServer versions 0.9.15 and prior (fixed in commit dc78dee) contain null pointer dereference vulnerabilities in the HTTP proxy handlers within httpProcessInput() in httpd.c that allow remote attackers to cause a denial of service by sending specially crafted HTTP requests. Attackers can exploit missing validation of strchr() return values in the CONNECT and GET proxy handling paths to trigger null pointer dereferences and crash the server when httpd and proxy features are enabled. |
| The Dhara flash translation layer disk driver (drivers/disk/ftl_dhara.c) implemented the dhara_nand_ callbacks so that, on a flash error, the error code was written unconditionally through the caller-supplied dhara_error_t err pointer (e.g. *err = DHARA_E_ECC in dhara_nand_read, and similar in dhara_nand_erase/prog/copy).
The upstream Dhara library calls these callbacks with err == NULL along its journal-resume binary search: find_last_checkblock() invokes find_checkblock(j, mid, &found, NULL), which forwards the NULL pointer into dhara_nand_read(). This path runs during disk_ftl_access_init() -> dhara_map_resume() whenever the FTL disk is mounted/initialised.
If a flash read error (uncorrectable ECC, bad block, controller error) occurs on one of the probed checkpoint pages, the driver dereferences and writes to NULL, faulting the kernel (denial of service). The trigger is conditioned on the NAND medium content/health, which can be influenced by media wear, induced faults, or a corrupted/crafted on-flash image.
The fix routes all error assignments through the library's NULL-safe dhara_set_error() helper. Affects Zephyr v4.4.0, where the driver was introduced. |
| The MAX32xxx USB device controller driver (drivers/usb/udc/udc_max32.c, compatible adi_max32_usbhs) dereferenced an endpoint buffer in its OUT and IN transfer-completion handlers without checking it for NULL. udc_event_xfer_out_done() called net_buf_add(buf, ep_request->actlen) immediately after buf = udc_buf_get(ep_cfg), where udc_buf_get() returns NULL when the endpoint FIFO is empty.
A transfer-completion event is queued from interrupt context and processed asynchronously by the driver thread; between queuing and processing, the endpoint FIFO can be drained by host-controlled control flow — in particular udc_setup_received() drains the EP0 OUT/IN FIFOs whenever a new SETUP packet arrives, and dequeue/disable/purge paths drain it likewise.
A USB host that aborts an in-flight EP0 control transfer with a new SETUP packet (legal USB behavior) can therefore cause a stale XFER_OUT_DONE event to be processed against an empty FIFO, producing net_buf_add(NULL, ...), a near-NULL pointer dereference that faults and crashes the device. No authentication is required; the attacker is the USB host the device is connected to (physical bus access). Impact is denial of service (device crash).
The defect was introduced when the MAX32 UDC driver was added and shipped in Zephyr v4.4.0. The fix adds NULL-buffer checks that return early with UDC_EVT_ERROR/-ENOBUFS in both the OUT-done and IN-done handlers. |
| mcumgr_serial_process_frag() in subsys/mgmt/mcumgr/transport/src/serial_util.c calls net_buf_reset() on the result of smp_packet_alloc() before checking it for NULL. smp_packet_alloc() uses net_buf_alloc(K_NO_WAIT) against the shared MCUmgr packet pool (CONFIG_MCUMGR_TRANSPORT_NETBUF_COUNT, default 4), which returns NULL when the pool is exhausted. In default builds the __ASSERT_NO_MSG in net_buf_reset is a no-op, so net_buf_simple_reset writes through the NULL pointer (buf->len = 0; buf->data = buf->__buf), causing a fault/crash.
The fragment data reaches this code from attacker-controlled bytes on the MCUmgr serial/UART/shell-console transports (smp_uart.c, smp_raw_uart.c, smp_shell.c), and a fresh buffer is allocated at the start of essentially every new packet. An attacker on the serial/console link can flood the transport to drive the 4-entry buffer pool to exhaustion and induce the NULL dereference, crashing the device (denial of service).
The defect was introduced after the original MCUmgr rework and shipped in Zephyr v4.4.0. The fix moves the NULL check ahead of net_buf_reset. |
| The Zephyr Bluetooth LE Audio Basic Audio Profile (BAP) unicast client mishandles peer-supplied ASE state notifications. In unicast_client_ep_qos_state() (subsys/bluetooth/audio/bap_unicast_client.c), the handler writes attacker-controlled QoS fields (interval, framing, phy, sdu, rtn, latency, pd) through the stream->qos pointer with only a stream != NULL guard. stream->qos is NULL for any stream that has been codec-configured via bt_bap_stream_config() but not yet added to a unicast group (it is set only by unicast_group_add_stream()).
A malicious or buggy remote ASCS server, to which the local device is connected as a BAP unicast client, can send a GATT notification announcing the ASE has entered the QoS Configured state while the local endpoint is still in the Codec Configured state — a transition the dispatcher explicitly permits — during that window, causing a write through a NULL pointer and a crash (denial of service). The data written is itself remote-controlled.
The defect shipped in v4.3.0 and v4.4.0 (and earlier). The fix re-points all BAP QoS storage to the always-valid embedded ep->qos struct, eliminating the NULL dereference. |
| Null pointer dereference in Active Directory Domain Services allows an authorized attacker to deny service over a network. |
| The CONFIG_USERSPACE verification handler for the k_thread_name_copy() system call (z_vrfy_k_thread_name_copy() in kernel/thread.c) calls k_object_find() on the caller-supplied thread pointer and then dereferences the returned struct k_object without checking it for NULL. k_object_find() returns NULL whenever the supplied pointer is not a registered (static or dynamic) kernel object.
The pre-fix guard tested thread == NULL instead of ko == NULL, so an unprivileged user-mode thread that invokes k_thread_name_copy() with any non-NULL but unregistered pointer (e.g. an arbitrary address) passes the NULL test, after which the verifier reads ko->type through a NULL pointer.
Because the syscall verifier runs in supervisor mode, this NULL dereference is a kernel-mode fault that halts or reboots the system, allowing untrusted user code to crash the kernel across the userspace security boundary (denial of service). The marshaller passes the thread argument to the verifier without any prior K_SYSCALL_OBJ validation, so the bad pointer reaches the defect directly.
The flaw affects builds with CONFIG_USERSPACE and CONFIG_THREAD_NAME enabled and has been present since the special-case lookup was introduced around v2.0.0; it is present in v4.4.0 and earlier. The fix changes the guard to check the k_object_find() return value (ko == NULL) before dereferencing it. |
| strongSwan versions 4.5.0 prior to 6.0.5 contain an integer underflow vulnerability in the EAP-TTLS AVP parser that allows unauthenticated remote attackers to cause a denial of service by sending crafted AVP data with invalid length fields during IKEv2 authentication. Attackers can exploit the failure to validate AVP length fields before subtraction to trigger excessive memory allocation or NULL pointer dereference, crashing the charon IKE daemon. |
| Crypt::OpenSSL::X509 versions before 2.1.3 for Perl allow denial of service via NULL pointer dereference.
X509V3_EXT_d2i(ext) returns NULL when an extension's DER value fails to parse. basicC, ia5string, and auth_att dereference its result without a NULL check. keyid_data also dereferences akid->keyid, which is NULL for an empty AKI SEQUENCE (DER 30 00) even when the parse succeeds.
A caller invoking an affected helper on an extension from an untrusted certificate triggers a SIGSEGV that crashes the Perl process. |
| A vulnerability was identified in open62541 up to 1.5.5. Affected by this issue is the function responseReadNamespacesArray of the file src/client/ua_client_connect.c of the component Shared Client Library. Such manipulation of the argument Server_NamespaceArray leads to null pointer dereference. The attack can be executed remotely. The attack requires a high level of complexity. The exploitation is known to be difficult. The exploit is publicly available and might be used. The project closed the issue report, stating that this is not the official way to report a security vulnerability. |
| A flaw was found in binutils, specifically within the `readelf` utility. This vulnerability allows a local attacker to cause a Denial of Service (DoS) by tricking a user into processing a specially crafted Executable and Linkable Format (ELF) file. The exploitation of this flaw can lead to the system becoming unresponsive due to excessive resource consumption or a program crash. |
| ImageMagick before 7.1.2-26 contains a heap use-after-free vulnerability caused by missing null check when parsing XMP profiles. Attackers can craft malicious image files with specially crafted XMP data to trigger the vulnerability and cause application crashes. |
| NATS Server is a high-performance server for NATS.io, the cloud and edge native messaging system. Prior to 2.12.8 and 2.11.17, an unauthenticated peer with network access to a leafnode listener with compression enabled could crash the server during the pre-authentication leafnode handshake by sending repeated leafnode INFO protocol messages before authentication and account setup completed. This issue is fixed in versions 2.12.8 and 2.11.17. |
