| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
i3c: master: renesas: Fix memory leak in renesas_i3c_i3c_xfers()
The xfer structure allocated by renesas_i3c_alloc_xfer() was never freed
in the renesas_i3c_i3c_xfers() function. Use the __free(kfree) cleanup
attribute to automatically free the memory when the variable goes out of
scope. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: Fix memory leak destroying device
All MT76 rx queues have an associated page_pool even if the queue is not
associated to a NAPI (e.g. WED RRO queues with WED enabled). Destroy the
page_pool running mt76_dma_cleanup routine during module unload.
Moreover returns pages to the page pool if WED is not enabled for WED RRO
queues. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: ath11k: fix memory leaks in beacon template setup
The functions ath11k_mac_setup_bcn_tmpl_ema() and
ath11k_mac_setup_bcn_tmpl_mbssid() allocate memory for beacon templates
but fail to free it when parameter setup returns an error.
Since beacon templates must be released during normal execution, they
must also be released in the error handling paths to prevent memory
leaks.
Fix this by using unified exit paths with proper cleanup in the respective
error paths.
Compile tested only. Issue found using a prototype static analysis tool
and code review. |
| In the Linux kernel, the following vulnerability has been resolved:
amd-pstate: Fix memory leak in amd_pstate_epp_cpu_init()
On failure to set the epp, the function amd_pstate_epp_cpu_init()
returns with an error code without freeing the cpudata object that was
allocated at the beginning of the function.
Ensure that the cpudata object is freed before returning from the
function.
This memory leak was discovered by Claude Opus 4.6 with the aid of
Chris Mason's AI review-prompts
(https://github.com/masoncl/review-prompts/tree/main/kernel). |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: fix memory leak in error path of hci_alloc_dev()
Early failures in Bluetooth HCI UART configuration leak SRCU percpu
memory.
When device initialization fails before hci_register_dev() completes,
the HCI_UNREGISTER flag is never set. As a result, when the device
reference count reaches zero, bt_host_release() evaluates this flag as
false and falls back to a direct kfree(hdev).
Because hci_release_dev() is bypassed, the SRCU struct initialized
early in hci_alloc_dev() is never cleaned up, resulting in a leak of
percpu memory.
Fix the leak by explicitly calling cleanup_srcu_struct() in the
fallback (unregistered) branch of bt_host_release() before freeing
the device. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/vc4: fix krealloc() memory leak
Don't just overwrite the original pointer passed to krealloc()
with its return value without checking latter:
MEM = krealloc(MEM, SZ, GFP);
If krealloc() returns NULL, that erases the pointer
to the still allocated memory, hence leaks this memory.
Instead, use a temporary variable, check it's not NULL
and only then assign it to the original pointer:
TMP = krealloc(MEM, SZ, GFP);
if (!TMP) return;
MEM = TMP;
While on it, use krealloc_array(). |
| In the Linux kernel, the following vulnerability has been resolved:
net: openvswitch: fix possible kfree_skb of ERR_PTR
After the patch in the "Fixes" tag, the allocation of the "reply" skb
can happen either before or after locking the ovs_mutex.
However, error cleanups still follow the classical reversed order,
assuming "reply" is allocated before locking: it is freed after unlocking.
If "reply" allocation happens after locking the mutex and it fails,
"reply" is left with an ERR_PTR, and execution jumps to the correspondent
cleanup stage which will try to free an invalid pointer.
Fix this by setting the pointer to NULL after having saved its error
value. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/v3d: Fix vaddr leak when indirect CSD has zeroed workgroups
v3d_rewrite_csd_job_wg_counts_from_indirect() maps both the indirect
buffer and the workgroup buffer and is expected to release them before
returning. When any of the workgroup counts read from the buffer is zero,
the function bailed out early and skipped the cleanup, leaking the vaddr
mappings of both BOs.
Jump to the cleanup path instead of returning directly, so the mappings
are always dropped. |
| In the Linux kernel, the following vulnerability has been resolved:
dm cache metadata: fix memory leak on metadata abort retry
When failing to acquire the root_lock in dm_cache_metadata_abort because
the block_manager is read-only, the temporary block_manager created
outside the root_lock is not properly released, causing a memory leak.
Reproduce steps:
This can be reproduced by reloading a new table while the metadata
is read-only. While the second call to dm_cache_metadata_abort is
caused by lack of support for table preload in dm-cache, mentioned
in commit 9b1cc9f251af ("dm cache: share cache-metadata object across
inactive and active DM tables"), it exposes the memory leak in
dm_cache_metadata_abort when the function is called multiple times.
Specifically, dm-cache fails to sync the new cache object's mode during
preresume, creating the reproducer condition.
This issue could also occur through concurrent metadata_operation_failed
calls due to races in cache mode updates, but the table preload scenario
below provides a reliable reproducer.
1. Create a cache device with some faulty trailing metadata blocks
dmsetup create cmeta <<EOF
0 200 linear /dev/sdc 0
200 7992 error
EOF
dmsetup create cdata --table "0 131072 linear /dev/sdc 8192"
dmsetup create corig --table "0 262144 linear /dev/sdc 262144"
dd if=/dev/zero of=/dev/mapper/cmeta bs=4k count=1 oflag=direct
dmsetup create cache --table "0 131072 cache /dev/mapper/cmeta \
/dev/mapper/cdata /dev/mapper/corig 128 1 writethrough smq 0"
2. Suspend and resume the cache to start a new metadata transaction and
trigger metadata io errors on the next metadata commit.
dmsetup suspend cache
dmsetup resume cache
3. Write to the cache device to update metadata
fio --filename=/dev/mapper/cache --name test --rw=randwrite --bs=4k \
--randrepeat=0 --direct=1 --size 64k
4. Preload the same table
dmsetup reload cache --table "$(dmsetup table cache)"
5. Resume the new table. This triggers the memory leak.
dmsetup suspend cache
dmsetup resume cache
kmemleak logs:
<snip>
unreferenced object 0xffff8880080c2010 (size 16):
comm "dmsetup", pid 132, jiffies 4294982580
hex dump (first 16 bytes):
00 38 b9 07 80 88 ff ff 6a 6b 6b 6b 6b 6b 6b a5 ...
backtrace (crc 3118f31c):
kmemleak_alloc+0x28/0x40
__kmalloc_cache_noprof+0x3d9/0x510
dm_block_manager_create+0x51/0x140
dm_cache_metadata_abort+0x85/0x320
metadata_operation_failed+0x103/0x1e0
cache_preresume+0xacd/0xe70
dm_table_resume_targets+0xd3/0x320
__dm_resume+0x1b/0xf0
dm_resume+0x127/0x170
<snip> |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: nft_fib: fix stale stack leak via the OIFNAME register
For NFT_FIB_RESULT_OIFNAME the destination register is declared with
len = IFNAMSIZ (four 32-bit registers), but on the lookup-fail,
RTN_LOCAL and oif-mismatch paths nft_fib{4,6}_eval() only writes one
register via "*dest = 0". The remaining three registers are left as
whatever was on the stack in nft_do_chain()'s struct nft_regs, and a
downstream expression that loads the register span can leak that
uninitialised kernel stack to userspace.
The NFTA_FIB_F_PRESENT existence check has the same shape: it is only
meaningful for NFT_FIB_RESULT_OIF, yet it was accepted for any result type
while the eval stores a single byte via nft_reg_store8(), leaving the rest
of the declared span stale.
Fix both:
- replace the bare "*dest = 0" in the eval with nft_fib_store_result(),
which strscpy_pad()s the whole IFNAMSIZ for OIFNAME (and is already
used on the other early-return path), and
- restrict NFTA_FIB_F_PRESENT to NFT_FIB_RESULT_OIF and declare its
destination as a single u8, so the marked span matches the one byte
the eval writes. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: nft_meta_bridge: fix stale stack leak via IIFHWADDR register
NFT_META_BRI_IIFHWADDR declares its destination register with
len = ETH_ALEN (6 bytes), which the register-init tracking rounds up to
two 32-bit registers (8 bytes). nft_meta_bridge_get_eval() then does
memcpy(dest, br_dev->dev_addr, ETH_ALEN), writing only 6 bytes and
leaving the upper 2 bytes of the second register as uninitialised
nft_do_chain() stack. A downstream load of that register span leaks
those stale bytes to userspace.
Zero the second register before the memcpy so the full declared span is
written. |
| A denial-of-service security issue exists within the 1794-AENTR adapter due to improper memory handling of CIP protocol requests. This vulnerability can result in the adapter faulting and losing connection to its associated I/O modules, requiring a manual reset to recover. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: sti: use managed regmap_field allocations
The regmap_field objects allocated at player init are never freed and
may leak resources if the driver is removed.
Switch to devm_regmap_field_alloc() to automatically limit the lifetime
of the allocations the lifetime of the device. |
| In the Linux kernel, the following vulnerability has been resolved:
devlink: Release nested relation on devlink free
devlink relation state is normally released from devl_unregister(), which
calls devlink_rel_put(). This misses devlink instances that get a nested
relation before registration and then fail probe before devl_register() is
reached.
That flow can happen for SFs. The child devlink gets linked to its
parent before registration, then a later probe error calls devlink_free()
directly. Since the instance was never registered, devl_unregister() is not
called and devlink->rel is leaked.
Release any pending relation from devlink_free() as well. The registered
path is unchanged because devl_unregister() already clears devlink->rel
before devlink_free() runs. |
| A vulnerability was found in the Infinispan component in Red Hat Data Grid. The REST compare API may have a buffer leak and an out of memory error can occur when sending continual requests with large POST data to the REST API. |
| In the Linux kernel, the following vulnerability has been resolved:
tee: shm: fix shm leak in register_shm_helper()
register_shm_helper() allocates shm before calling
iov_iter_npages(). If iov_iter_npages() returns 0, the function
jumps to err_ctx_put and leaks shm.
This can be triggered by TEE_IOC_SHM_REGISTER with
struct tee_ioctl_shm_register_data where length is 0.
Jump to err_free_shm instead. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: Fix memory leak after mt76_connac_mcu_alloc_sta_req()
mt76_connac_mcu_alloc_sta_req() allocates an skb which is expected to
be freed eventually by mt76_mcu_skb_send_msg(). However, currently if
an intermediate function fails before sending, the allocated skb is
leaked.
Specifically, mt76_connac_mcu_sta_wed_update() and
mt76_connac_mcu_sta_key_tlv() may fail, leading to an immediate memory
leak in the error path.
Fix this by explicitly freeing the skb in these error paths.
Commit 7c0f63fe37a5 ("wifi: mt76: mt7996: fix memory leak on
mt7996_mcu_sta_key_tlv error") made a similar change.
Compile tested only. Issue found using a prototype static analysis tool
and code review. |
| In the Linux kernel, the following vulnerability has been resolved:
block: fix zones_cond memory leak on zone revalidation error paths
When blk_revalidate_disk_zones() fails after disk_revalidate_zone_resources()
has allocated args.zones_cond, the memory is leaked because no error path
frees it. |
| In the Linux kernel, the following vulnerability has been resolved:
tap: fix stack info leak in tap_ioctl() SIOCGIFHWADDR
In the SIOCGIFHWADDR path, tap_ioctl() copies 16 bytes of an
uninitialised on-stack struct sockaddr_storage to userspace via
ifr_hwaddr, but netif_get_mac_address() only writes sa_family and
dev->addr_len (6 for Ethernet) bytes, leaving sa_data[6..13] uninitialised.
Those 8 trailing bytes leak kernel stack contents; SIOCGIFHWADDR on a
macvtap chardev returns kernel .text and direct-map pointers, defeating
KASLR.
Initialise ss at declaration. |
| In the Linux kernel, the following vulnerability has been resolved:
net_sched: fix skb memory leak in deferred qdisc drops
When the network stack cleans up the deferred list via qdisc_run_end(),
it operates on the root qdisc. If the root qdisc do not implement the
TCQ_F_DEQUEUE_DROPS flag the packets queue to free are never freed and
gets stranded on the child's local to_free list.
Fix this by making qdisc_dequeue_drop() aware of the root qdisc. It
fetches the root qdisc and check for the TCQ_F_DEQUEUE_DROPS flag. If
the flag is present, the packet is appended directly to the root's
to_free list. Otherwise, drop it directly as it was done before the
optimization was implemented. |
