| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
vhost/vdpa: validate virtqueue index in mmap and fault paths
vhost_vdpa_mmap() and vhost_vdpa_fault() use vma->vm_pgoff as a
virtqueue index for get_vq_notification(), but they do not validate
that the index is smaller than v->nvqs.
The ioctl path already performs both a bounds check and
array_index_nospec(), but the mmap/fault path only checks that the
index fits in u16. This allows an out-of-range queue index to reach
driver-specific get_vq_notification() callbacks.
Fix this by extracting a unified vhost_vdpa_get_vq_notification()
helper that validates the queue index against v->nvqs and applies
array_index_nospec() before calling the driver callback. Both the
mmap and fault paths use this helper, and the bounds checking is
consolidated into a single location.
From source inspection, the most defensible impact is out-of-bounds
access in the callback path, potentially leading to invalid PFN
remaps and crash/DoS. |
| In the Linux kernel, the following vulnerability has been resolved:
virtio: rtc: tear down old virtqueues before restore
virtio_device_restore() resets the device and restores the negotiated
features before calling ->restore(). viortc_freeze() intentionally
leaves the existing virtqueues in place so the alarm queue can still
wake the system, but viortc_restore() immediately calls
viortc_init_vqs() without first deleting those old queues.
If virtqueue reinitialization fails on virtio-pci, the transport error
path can run vp_del_vqs() against a newly allocated vp_dev->vqs array
while vdev->vqs still contains the old virtqueues. vp_del_vqs() then
looks up queue state through the new array and can dereference a NULL
info pointer in vp_del_vq(), crashing the guest kernel during restore.
This can also happen during a non-faulty reinitialization, when one of
the vp_find_vqs_msix() attempts is unsuccessful before a later attempt
would succeed.
Delete the stale virtqueues before rebuilding them. If restore fails
before virtio_device_ready(), reuse the remove path to stop the device.
Once the device is ready, return errors directly instead of deleting the
virtqueues again. |
| In the Linux kernel, the following vulnerability has been resolved:
vhost/net: complete zerocopy ubufs only once
vhost-net initializes one ubuf_info per outstanding zerocopy TX
descriptor and hands it to the backend socket. The networking stack may
then clone a zerocopy skb before all skb references are released. For
example, batman-adv fragmentation reaches skb_split(), which calls
skb_zerocopy_clone() and increments the same ubuf_info refcount.
vhost_zerocopy_complete() currently treats every ubuf callback as a
completed vhost descriptor. It dereferences ubuf->ctx, writes the
descriptor completion state, and drops the vhost_net_ubuf_ref even when
the callback only releases a cloned skb reference. A backend reset can
therefore wait for and free the vhost_net_ubuf_ref while another cloned
skb still carries the same ubuf_info. A later completion then
dereferences the freed ubufs pointer.
KASAN reports the stale completion as:
BUG: KASAN: slab-use-after-free in vhost_zerocopy_complete+0x1d7/0x1f0
BUG: KASAN: slab-use-after-free in vhost_zerocopy_complete+0x101/0x1f0
vhost_zerocopy_complete
skb_copy_ubufs
__dev_forward_skb2
veth_xmit
The freed object was allocated from vhost_net_ioctl() while setting the
backend and freed through kfree_rcu()/kvfree_rcu_bulk after backend
removal, while delayed skb completion still reached
vhost_zerocopy_complete().
Honor the generic ubuf_info refcount before touching vhost state, and run
the vhost descriptor completion only for the final ubuf reference. This
matches the msg_zerocopy_complete() ownership rule for cloned zerocopy
skbs. |
| In the Linux kernel, the following vulnerability has been resolved:
vdpa/octeon_ep: fix IRQ-to-ring mapping in interrupt handler
Look up the IRQ index in oct_hw->irqs instead of assuming
irq - irqs[0]. This supports non-contiguous IRQ numbers and
avoids incorrect ring indexing when irqs[0] is not the base. |
| In the Linux kernel, the following vulnerability has been resolved:
ext4: fix kernel BUG in ext4_write_inline_data_end
When the data=journal mount option is used, the ext4_journalled_write_end()
function incorrectly calls ext4_write_inline_data_end() without checking
if the EXT4_STATE_MAY_INLINE_DATA flag is still set on the inode.
If a previous attempt to convert the inline data to an extent failed (e.g.
due to ENOSPC), the EXT4_STATE_MAY_INLINE_DATA flag is cleared, but
the EXT4_INODE_INLINE_DATA flag remains set. In this scenario, the next
call to ext4_write_begin() will not prepare the inline data xattr for
writing, but ext4_journalled_write_end() will incorrectly attempt to write
to it, triggering a BUG_ON(pos + len > EXT4_I(inode)->i_inline_size) in
ext4_write_inline_data() since i_inline_size was not expanded.
Fix this by ensuring that ext4_journalled_write_end() only calls
ext4_write_inline_data_end() if the EXT4_STATE_MAY_INLINE_DATA flag is
set, mirroring the behavior of ext4_write_end() and ext4_da_write_end(). |
| In the Linux kernel, the following vulnerability has been resolved:
ext4: validate donor file superblock early in EXT4_IOC_MOVE_EXT
Reject the EXT4_IOC_MOVE_EXT ioctl early if the donor file does not
belong to the same superblock as the original file. Currently, this
validation is performed inside ext4_move_extents() by
mext_check_validity(), but only after lock_two_nondirectories() has
already acquired the inode locks. When the donor fd refers to a file
on a different filesystem (e.g., overlayfs), this late validation
creates a circular lock dependency:
CPU0 (overlayfs write) CPU1 (ext4 ioctl)
---- ----
inode_lock(ovl_inode)
mnt_want_write_file(filp)
sb_start_write(ext4_sb) [sb_writers]
backing_file_write_iter()
vfs_iter_write(real_file)
file_start_write(real_file)
sb_start_write(ext4_sb) [blocked by freeze]
lock_two_nondirectories()
inode_lock(ovl_inode) [blocked]
With a concurrent freeze operation holding sb_writers write side, this
forms a deadlock cycle: CPU0 waits for freeze to complete, freeze waits
for CPU1's sb_writers reader to exit, CPU1 waits for CPU0's inode lock.
Since EXT4_IOC_MOVE_EXT exchanges physical extents between two files,
it fundamentally requires both files to reside on the same ext4
filesystem. Moving the superblock check before any lock acquisition
is both semantically correct and eliminates the circular dependency
by ensuring that cross-filesystem donor fds are rejected before
sb_writers or inode locks are taken. |
| In the Linux kernel, the following vulnerability has been resolved:
vfio/qat: fix f_pos race in qat_vf_resume_write()
qat_vf_resume_write() checks filp->f_pos before taking migf->lock, but
copies into the migration-state buffer after taking the lock and
re-reading the shared file position.
Two concurrent writers could therefore pass the bounds check with the
old offset, then have the second writer copy after the first advanced
f_pos, writing past the end of the migration-state buffer.
Take migf->lock before doing the boundary checks. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Tighten cgroup storage cookie checks for prog arrays
The fix in commit abad3d0bad72 ("bpf: Fix oob access in cgroup local
storage") is still incomplete. The prog-array compatibility check
treats a program with no cgroup storage as compatible with any stored
storage cookie. This allows a storage-less program to bridge a tail
call chain between an entry program and a storage-using callee even
though cgroup local storage at runtime still follows the caller's
context, that is, A -> B(no storage) -> C(storage) path.
Requiring exact cookie equality would break the legitimate case of a
storage-less leaf program being tail called from a storage-using one.
Instead, only accept a zero storage cookie if the program cannot
perform tail calls itself. This keeps A -> B(no storage) working
while rejecting the A -> B(no storage) -> C(storage) bridge. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_qca: fix NULL pointer dereference in qca_setup() for non-serdev device
hu->serdev is NULL for hci_uart attached via non-serdev paths, but
qca_setup() unconditionally calls serdev_device_get_drvdata(hu->serdev)
and dereferences the result, causing a NULL pointer dereference.
Fix by guarding the dereference with a NULL check, consistent with the
rest of qca_setup(). |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_qca: fix NULL pointer dereference in qca_dmp_hdr() for non-serdev device
hu->serdev is NULL for hci_uart attached via non-serdev paths, but
qca_dmp_hdr() unconditionally dereferences hu->serdev->dev.driver->name,
causing a NULL pointer dereference.
Fix by guarding the dereference with a NULL check and falling back to
"hci_ldisc_qca" for the non-serdev case. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_core: Fix UAF in hci_unregister_dev()
hci_unregister_dev() does not disable cmd_timer and ncmd_timer
before the hci_dev structure is freed. If a timeout fires
during device teardown, the callback dereferences freed memory
(including the hdev->reset function pointer), leading to a
use-after-free.
Add disable_delayed_work_sync() calls alongside the existing
disable_work_sync() calls to ensure both timers are fully
quiesced before teardown proceeds. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btmtk: fix URB leak in alloc_mtk_intr_urb error path
When btmtk_isopkt_pad() fails, the previously allocated URB is not freed,
leaking the urb structure. Add usb_free_urb() before returning the error. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci: validate codec capability element length
Read Local Codec Capabilities returns a sequence of capability elements.
Each element starts with a one-byte length followed by that many payload
bytes.
hci_read_codec_capabilities() checks that the skb contains the length
byte, but then validates only caps->len against the remaining skb
length. A malformed controller response with one remaining byte and
caps->len set to one passes that check even though the element needs two
bytes. The parser then records a two-byte capability and copies one
byte beyond the advertised response payload into the codec list.
Validate the full element size, including the length byte, before adding
it to the accumulated capability length. This preserves all well-formed
capability elements and drops only truncated controller responses. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/core: Fix FRMR aging push to queue error flow
Aging pools with pinned handles requires moving handles from the
active queue to a non-empty inactive queue that might fail on new page
allocation, we are currently not handling the fault and leaking any mkey
that fails the push.
Fix by Introducing push_queue_to_queue_locked() that fills the
destination's partial tail page from the source and then splices the
remaining source pages onto the destination, performing no allocation.
Replace the per-handle move loop in age_pinned_pool() and the
open-coded splice in pool_aging_work() with calls to the helper.
As the helper cannot fail under memory pressure, removing a class of
GFP_ATOMIC allocations under the pool lock and simplifying the error
flow. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/core: Fix FRMR set pinned push error path
Add destruction of FRMR handles in case the push to the pool fails.
This prevents resources leak in case pool page allocation fails. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/mlx5: Fix undefined shift of user RQ WQE size
set_rq_size() computes the RQ WQE size as "1 << rq_wqe_shift" based on
the user-provided rq_wqe_shift, which is only checked to be greater than
32, so shifts of 32 are still accepted. A shift of 31 also overflows a
signed integer, leading to undefined behavior.
Use check_shl_overflow() to compute the RQ WQE size and reject any
invalid values. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/mlx5: Release the HW‑provided UAR index rather than the SW one
Free the UAR index returned by the hardware. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: codecs: hdac_hdmi: Validate written enum value
hdac_hdmi_set_pin_port_mux() uses the written enum value to index the
texts array before calling snd_soc_dapm_put_enum_double(), which validates
that the value is within the enum item range.
An out-of-range value can therefore make the driver read past the texts
array before the helper rejects the write. Move the lookup after the helper
has accepted the value. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: meson: aiu: Validate written enum values
The AIU HDMI and internal codec mux put callbacks use the written enum
value with snd_soc_enum_item_to_val() before checking whether the value is
valid for the enumeration.
Reject out-of-range values before converting the enum item, matching the
validation already done by the G12A HDMI and internal codec mux controls. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: fsl: fsl_audmix: Validate written enum values
fsl_audmix_put_mix_clk_src() and fsl_audmix_put_out_src()
convert the user-provided enum item with snd_soc_enum_item_to_val()
before checking whether the item is within the enum's item count.
The generic snd_soc_put_enum_double() helper performs that
validation, but these callbacks use the converted value first: the
clock-source path tests it with BIT(), and the output-source path
indexes the prms transition table with it.
Reject out-of-range enum items before converting them. |
