| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmfmac: make release_scratchbuffers idempotent
brcmf_pcie_release_scratchbuffers() frees the shared.scratch and
shared.ringupd DMA buffers with dma_free_coherent() but does not clear
the pointers afterwards, unlike the sibling release_ringbuffers() which
NULLs commonrings/flowrings/idxbuf on release.
Both the bus_reset .reset callback (brcmf_pcie_reset) and
brcmf_pcie_remove() call release_scratchbuffers. When reset teardown
has run before removal, remove's own teardown would call
dma_free_coherent() a second time on the already-freed DMA allocation.
NULL the pointers after free, matching release_ringbuffers(), so a later
release observes that the allocation has already been released. This
patch makes repeated sequential release safe; the reset-work lifetime is
handled separately by the following patch.
This issue was found by an in-house static analysis tool. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_uart: clear HCI_UART_SENDING when write_work is canceled
HCI_UART_SENDING bit in tx_state means write_work is pending and blocks
queueing it again. Currently this bit is not cleared when canceling the
work in hci_uart_close(), which blocks future writes when device is
reopened later if write_work was pending.
Fix by clearing HCI_UART_SENDING when canceling the work.
Also make clearing of tx_skb safe by using disable_work_sync +
enable_work instead of just cancel_work_sync. hci_uart_flush() purges
the proto tx queue so we can cancel the pending write_work there,
instead of doing it just in hci_uart_close(). Re-enable and possibly
requeue the work after queue flush. |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix double-free in SMB2_close() replay
A response-bearing attempt can return a replayable error and free its
response buffer. If SMB2_close_init() fails before the next send, cleanup
retains the previous buffer type and frees that response again.
Reset response bookkeeping before each attempt to prevent the stale free. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: mgmt: fix locking in unpair_device/disconnect_sync
Dereferencing RCU-protected pointers outside critical sections is
invalid and may lead to UAF.
Take hdev->lock for hci_conn lookup and hci_abort_conn(). Don't use RCU
to ensure the conn is fully initialized at this point. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_sync: hold hdev->lock for hci_conn_params lookups
hci_conn_params_lookup requires hdev->lock be held, otherwise the list
iteration or param access is not safe.
Hold hdev->lock for params lookups in hci_sync. |
| In the Linux kernel, the following vulnerability has been resolved:
can: raw: add locking for raw flags bitfield
With commit 890e5198a6e5 ("can: raw: use bitfields to store flags in
struct raw_sock") the formerly separate integer values have been integrated
into a single bitfield. This led to a read-modify-write operation when
changing a flag in raw_setsockopt() which now needs a locking to prevent
concurrent access.
Instead of adding a lock/unlock hell in each of the flag manipulations this
patch introduces a wrapper for a new raw_setsockopt_locked() function
analogue to the isotp_setsockopt[_locked]() approach in net/can/isotp.c
[mkl: use Closes tag instead of Link] |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: set new_stream to NULL after release
In dm_update_crtc_state(), the skip_modeset path releases new_stream
via dc_stream_release() but does not set the pointer to NULL.
If a later error (e.g., color management failure) triggers the fail
label, the error path calls dc_stream_release() again on the same
dangling pointer, causing a double release and potential use-after-free.
Fix this by setting new_stream to NULL after the initial release.
(cherry picked from commit 99f3af19073b3ddbfd96e789124cce12c4277b28) |
| In the Linux kernel, the following vulnerability has been resolved:
media: vivid: check for vb2_is_busy() when toggling caps
The vivid_update_format_cap/out() functions must only be called if the
capture/output queue are not busy. But for the controls that select
the CROP/COMPOSE/SCALE capability that is not checked.
Only when streaming starts will they be set to 'grabbed' and it is
impossible to change the control, but between REQBUFS and STREAMON you
are still allowed to set these controls. Since vivid_update_format_cap/out
will change the format, this can cause unexpected results.
Besides adding these checks, also add a WARN_ON in
vivid_update_format_cap/out() if the queue is busy.
I'm 90% certain that this is the cause of this syzbot bug:
https://syzkaller.appspot.com/bug?extid=dac8f5eaa46837e97b89
But since we never have reproducers, it is hard to be certain. In any case,
these checks are needed regardless. |
| In the Linux kernel, the following vulnerability has been resolved:
phonet: pep: fix use-after-free in pep_get_sb()
pep_get_sb() doesn't consider that pskb_may_pull() might have relocated
the skb data, and continue to access the older pointer, causing UAF.
Reproduced under KASAN:
BUG: KASAN: slab-use-after-free in pep_get_sb+0x234/0x3b0
Read of size 1 at addr ff11000105510f50 by task repro/157
pep_get_sb+0x234/0x3b0
pipe_handler_do_rcv+0x5f7/0xa10
pep_do_rcv+0x203/0x410
__sk_receive_skb+0x471/0x4a0
phonet_rcv+0x5b3/0x6c0
__netif_receive_skb+0xcc/0x1d0
Refetch the header with skb_header_pointer() after pskb_may_pull(), so
the possibly stale pointer is no longer dereferenced. There are better
ways to solve this, but, this is the less instrusive one. |
| A double free issue has been identified in libarchive's RAR5 reader. During parsing of a specially crafted RAR5 archive, the filtered_buf pointer may remain stale after being freed during unpacking state reinitialization. Subsequent processing of another archive entry can trigger a second free of the same memory region, resulting in a double-free condition. Successful exploitation may cause applications using the vulnerable libarchive API to terminate unexpectedly, leading to a denial of service. |
| It was discovered that a nft object or expression could reference a nft set on a different nft table, leading to a use-after-free once that table was deleted. |
| A use-after-free exists in the Linux Kernel in tc_new_tfilter that could allow a local attacker to gain privilege escalation. The exploit requires unprivileged user namespaces. We recommend upgrading past commit 04c2a47ffb13c29778e2a14e414ad4cb5a5db4b5 |
| In the Linux kernel, the following vulnerability has been resolved:
PCI: endpoint: pci-ep-msi: Fix error unwind and prevent double alloc
pci_epf_alloc_doorbell() stores the allocated doorbell message array in
epf->db_msg/epf->num_db before requesting MSI vectors. If MSI allocation
fails, the array is freed but the EPF state may still point to freed
memory.
Clear epf->db_msg and epf->num_db on the MSI allocation failure path so
that later cleanup cannot double-free the array and callers can retry
allocation.
Also return -EBUSY when doorbells have already been allocated to prevent
leaking or overwriting an existing allocation. |
| Use after free in Windows DWM Core Library allows an authorized attacker to elevate privileges locally. |
| Double free in Windows Secure Socket Tunneling Protocol (SSTP) allows an unauthorized attacker to execute code over a network. |
| Use after free in Capability Access Management Service (camsvc) allows an authorized attacker to elevate privileges locally. |
| In the Linux kernel, the following vulnerability has been resolved:
power: reset: linkstation-poweroff: fix use-after-free in the linkstation_poweroff_init()
Move of_node_put(dn) after the of_match_node() call, which still needs
the node pointer. The node reference is correctly released after use. |
| In the Linux kernel, the following vulnerability has been resolved:
fpga: region: fix use-after-free in child_regions_with_firmware()
Move of_node_put(child_region) after the error print to avoid accessing
freed memory when pr_err() references child_region.
[ Yilun: Fix the Fixes tag ] |
| Use after free in Windows Autopilot allows an authorized attacker to elevate privileges locally. |
| Use after free in Windows Autopilot allows an authorized attacker to elevate privileges locally. |
